David Lanzendörfer schreef op wo 07-03-2018 om 18:45 [+0800]:

Hi

Otherwise I would have to experiment around a few times until I get it right 
with orientation numbers I find with Googling ^^'

David, I want to be blunt; if you are not prepared to do this for most of the steps in the process it's time to stop the project now. As I said already during the phone I consider what you guys are currently doing is preparation to start the process development.

For the litho steps you will also need to determine best dose and focus, check if alignment works. For dry etching steps you will need to determine the end point detection, etc.

Let me compare it to some guys who have read some paper on operating system development, have now made a schematic layout of how the OS will look and now in the process of planning to start to write the first code...

greets,

Staf.